Lippert Components OCTP - Generator Operation; HVAC System Control

Rev: 12.21.18 Page 5
CCD-0001440
5. Generator, if equipped:
A. Pressing the Generator icon (Fig. 2) will allow you to access the generator control screen (Fig. 7).
B. Select a generator to operate.
I. To start the generator, press the START button (Fig. 7A).
II. To access the auto-start menu and set maintenance intervals, choose auto-start voltage, etc.,
press the SETTINGS button (Fig. 7B) on the left side of the screen.
6. HVAC, if equipped:
A. Pressing the HVAC icon (Fig. 2) will allow you to access the HVAC control screen (Fig. 8).
B. Select an HVAC zone to control (Fig. 8A).
C. Selecting a zone will bring you to the climate zone control screen.
I. Toggle the heating or cooling on or off by pressing the HVAC control button (Fig. 9A).
II. Adjust the fan strength by pressing the HVAC fan control button (Fig. 9B).
A
Fig. 8
A
B
Fig. 9
A
Fig. 7
B