Lippert Components SolidStep 3.0 Owner's Manual

Rev: 07.19.18 Page 3
CCD-0001657
Operation
Release Steps
1. Disengage transport lock (Fig. 1).
2. Firmly grasp and pull out the vertically stored SolidStep® and firmly rest it on the ground.
3. Adjust leg extensions as needed, see Leg Extension Adjustment section.
A
B
C
Storage of Steps
1. Retract leg extensions, if desired.
2. Lift up SolidStep® to its stored position and make sure the transport lock has been engaged.
Adjust Leg Extension
The leg extension is secured with a quick release clevis pin. Adjustments can be made to the leg extensions
in 1" increments by extending or retracting the inner leg for the optimal angle and to adjust for the ground
surface angle.
1. To extend the inner leg (Fig. 2B):
A. Remove the quick release clevis pin (Fig. 2A) from the tube and the slot in the angle.
B. Extend the inner leg to the ground and at an angle so the steps are parallel to the ground and
level.
C. Reinsert the quick release clevis pin into the tube and slot closest to where the inner leg and tube
(Fig. 2C) meet.
2. To retract the inner leg:
A. Remove the quick release clevis pin from the tube and slot.
B. Retract the inner leg.
C. Reinsert the quick release clevis pin into the tube and slot.
Fig. 1
Fig. 2
Transport Lock

Lippert Components SolidStep 3.0 Specifications

General

Brand	Lippert Components
Model	SolidStep 3.0
Category	Ladders
Language	English