What to do if my Lippert Components Automobile Accessory unit is not powered?
If your Lippert Components Automobile Accessory unit isn't powering on, there are a couple of things you can check: * The unit might be in a low power state. Try activating the tow vehicle brake to wake it. * The unit may not be properly connected to the DC 12V power supply. Double-check the wiring to ensure it's correctly connected.
General| Product Type | Sway Control System |
|---|---|
| Manufacturer | Lippert Components |
| Power Source | 12V DC |
| Mounting Location | Trailer frame |
| Control Method | Electronic |
| Activation | Automatic |
Highlights procedures with safety risks causing death, injury, or damage.
Warns against submerging the controller, which can cause non-warrantable damage.
Advises wearing safety gear and avoiding damage to the controller.
Instructs on proper looming and securing of wiring harnesses.
Details routing and securing of the wiring harness.
Instructions for attaching the light pod to the caravan's A-frame.
Instructions for attaching the light pod to the caravan wall.
Procedure for end-of-line testing using a vehicle simulator box.
Explains light pod indicators and troubleshooting steps for faults.
To Next Page
