What does Green, Red, Repeat mean on my Lippert Components Controller?
If your Lippert Components Sway Command displays Green, Red, Repeat, it means that wake up self-checks are in progress. After a few seconds, the Sway Command will complete these checks and the light will turn green if the Sway Command is ready. If an issue is found, a flashing code will appear.
How to fix a short to 12 volt detected in Lippert Components Automobile Accessories?
If a short to 12 volts is detected in your Lippert Components Automobile Accessories, ensure that the break away switch is not activated. Also, verify that the blue brake wire isn't shorted to 12 volts.
What to do if Lippert Components Automobile Accessory is not connected to trailer brakes?
If your Lippert Components Automobile Accessory indicates it's not connected to the trailer brakes, verify that the blue brake wire is securely connected to the trailer brakes.
How to troubleshoot a short to ground detected in Lippert Components Automobile Accessories?
If a short to ground is detected in your Lippert Components Automobile Accessories, check that the blue brake wire isn't shorted to ground or the trailer frame.
Why is low voltage detected in my Lippert Components Automobile Accessories?
If low voltage is detected in your Lippert Components Automobile Accessories, make sure that both the tow vehicle and tow battery are at 12 volts.
What to do if my Lippert Components Automobile Accessory unit is not functional?
If your Lippert Components Automobile Accessory unit isn't working, try this: disconnect the harness, wait 10 seconds, and then reconnect it. If the light turns on solid red, unplug the unit and contact the service department.
What to do if my Lippert Components Controller shows Green, 5 Red?
If your Lippert Components Controller displays Green, 5 Red, it means low voltage has been detected. Verify that both the tow vehicle and tow battery are at 12 volts.
What does Green, 3 Red mean on my Lippert Components Controller?
If your Lippert Components Controller displays Green, 3 Red, it indicates that it is not connected to the caravan brakes. To resolve this, verify that the blue brake wire is connected to the caravan brakes.
What to do if the Lippert Components Controller shows a Red Fast Blink?
If the Lippert Components Sway Command is not functional and displays a Red Fast Blink, disconnect the harness, wait 10 seconds, and then reconnect it. If the light then comes on solid red, unplug the Sway Command.
What to do if the Lippert Components Controller shows a Red Solid light?
If the Lippert Components Sway Command is not functional and shows a Red Solid light, disconnect the harness, wait 10 seconds, and then reconnect the harness.
General| Product Type | Sway Control System |
|---|---|
| Manufacturer | Lippert Components |
| Power Source | 12V DC |
| Mounting Location | Trailer frame |
| Control Method | Electronic |
| Activation | Automatic |
To Next Page
