Rev: 10.18.21 Page 17 CCD-0004098
5. Lower the driver's side patio railing assembly (Fig. 38A) approximately 45 degrees down towards
the center of the ramp door.
6. Fold the front panel and gate (Fig. 39A) over the top of the side patio railing, then raise the patio railing
to the 90 degree position (Fig. 40).
Fig. 40
Fig. 39
A
7. Attach the two snaps holding the front panel and gate to the driver's side railing (Fig. 40A) or for the
no-gate option, one snap holding the front panel to the side panel.
8. Attach the rear driver's side bungee cable (Fig. 40B) to the footman loop (Fig. 40C) located on
the door jamb.
A
Fig. 38
A A
B
C
To Next Page
Loading...