Lippert 3000 Series - Page 18

Rev: 10.18.21 Page 18 CCD-0004098
10. For the curbside patio railing, swing the front panel (Fig. 42A) out in-line with the side patio railing (Fig. 43A).
11. If applicable, disengage the J-lock (Fig. 3) on the curbside of the patio railing.
12. Lower the curbside patio railing assembly (Fig. 44A) approximately 45 degrees down towards the
center of the ramp door.
13. Fold the front panel (Fig. 45A) over the top of the side patio railing, then raise the patio railing to the 90
degree position (Fig. 46).
A
B
C
Fig. 42
A
A
Fig. 43
Fig. 45
A
Fig. 44
A
Fig. 41
9. Located towards the top of the ramp door, release the curbside front panel bottom leg (Fig. 41A) from
the keeper (Fig. 41B) by pushing the compression latch lever (Fig. 41C) towards the coach and slide the
leg out from the keeper.