Rev: 10.27.22 Page 10 CCD-0005287
Level Zero Point Calibration
The Zero Point Calibration has been set by the RV manufacturer and verified by the RV dealer. If a new zero
point is desired, proceed with this section. The “Zero Point” is the programmed point that the trailer will
return to each time the Auto Level feature is used. The “Zero Point” must be programmed prior to using the
Auto Level feature to ensure the proper operation of the system. This mode is enabled by performing the
following sequence:
NOTE: Parking brake MUST be ON in order to operate the leveling system.
NOTE: The LED touchpad controller is only ON while the coach ignition is ON, no operation of leveling is
allowed without the ignition source. Once power is on, the LED touchpad controller will illuminate.
1. Go to the Menu button (Fig. 15A) and select the Calibration button (Fig. 15B).
2. Select the arrow on the touchpad that is the direction of the display of the touchscreen is facing
related to the coach (Fig. 16).
Fig. 15
Fig. 16
Menu Screen
A
B
To Next Page
Loading...
