Rev: 10.27.22 Page 11 CCD-0005287
3. Follow the directions on the next screen (Fig. 17) to calibrate the LED touchpad controller. Place a level
on the floor of the coach to ensure a level reference point in the coach. Press “LEVEL VEHICLE”
on the touchpad.
Fig. 17
4. The next screen that follows (Fig. 18) shows four extend buttons that activates each pair of valves,
directional control valve and solenoid. The "CONFIRM LEVEL" button is a latching button that zeros
out the control accelerometer and stores that exact position as level. After the initial calibration, when
the user presses “AUTO LEVEL”, the control recognizes that position as level and will bring the coach
to that position.
5. Level the coach in the manual "CALIBRATION" mode by using a carpenter’s level on the floor.
Level front to rear and then left to right.
A. Push the "EXTEND FRONT" (Fig. 18A) button until jacks contact the ground and lift the front
of the coach 1-2 inches.
Fig. 18
A
B C
D
E
To Next Page
Loading...
