Rev: 10.27.22 Page 12 CCD-0005287
A. Push "EXTEND REAR" (Fig. 18D) button until jacks contact the ground and lift rear of coach.
Continue to use EXTEND REAR and EXTEND FRONT buttons until the carpenter's level bubble is
centered.
B. Push "EXTEND DRIV SIDE" (Fig. 18B) and "EXTEND PASS SIDE" (Fig. 18C) buttons until level
bubble is centered.
NOTE: Wait 10 seconds after operating jacks to ensure vehicle is completely still before pressing CONFIRM
LEVEL.
6. With the coach leveled, press “CONFIRM LEVEL” (Fig. 18E)
7. The touch pad is now in zero mode. If the coach has come out of it’s level condition, it can be reset
into level condition by following the procedure outlined in step 3.
NOTE: During the “auto level” process, if too much time has passed (180 seconds) or if control was calling
to extend pair of jacks but saw zero movement (angle change) meaning the cylinders have reached
full stroke, or coach is parked on too great of an incline (typically over 6 degrees) and cannot
complete level process. A "LEVELING ERROR" screen (Fig. 19) will appear. Press Home (Fig. 19A) or
Menu (Fig. 19B) icons to get out of this page.
Fig. 19
A B
To Next Page
Loading...
