TI-478 CCD-0007863
REV: 09.19.2023
Page 3
Preparation
NOTE: Only use FlowMax Seat Assembly Kit on the FlowMax Toilet to ensure it is the
proper size and completely functional.
1. Before removal, clean the old seat as well as the toilet bowl and rim.
2. At the back of the bowl, locate lever (Fig. 1A) on the back of the seat assembly.
A
Resources Required
∆ Phillips screwdriver
∆ Flat blade screwdriver
∆ Adjustable wrench
∆ Hose clamp (if necessary)
∆ Side-cut pliers
NOTE: Figure 1 shows the back of the FlowMax Toilet. On the left, the back of the
toilet and water inlet is shown. On the right, the back of the toilet has been removed
to better show the lever (Fig. 1A).
Fig.1
To Next Page
Loading...