TI-478 CCD-0007863REV: 09.19.2023 Page 6
Installation
1. Remove new seat from packaging.
2. Install the seat assembly pieces as follows:
A. Expanding Seat Nuts (Fig. 4A)
B. Toilet Seat Base (Fig. 4B)
C. Adjustable Seat Blocks (Fig. 4C)
D. Flathead Screws (Fig. 4D)
3. Tighten Flathead Screws with a screwdriver to secure toilet seat base to
FlowMax Bowl (Fig. 4E).
4. Apply the lid and Seat Assembly (Fig. 4F) by sliding it onto and over the
installed Toilet Seat Base.
5. Listen for a clicking sound once it is locked into place.
Post-Installation Checks
1. Open and close the lid making sure it completely closes over the seat.
2. Jiggle the seat to conrm that it is secure.
To Next Page
Loading...