Lippert Level-up - Operation; Unhitching and Auto Level; Reconnect and Auto Retract

12/15/2022
8
OPERATION
• Unhitching (Extend Landing Gear Jacks)
• Auto Level
• Reconnect (Left and Right/Auto Hitch/Hitch Height)
• Auto Retract (Auto Retract/Retract All)
LCD Touch Pad
Auto Leveling
Control Touch Pad
OneControl Touch Panel
Error Codes
Out of Stroke
Jack Time Out
Feature Disabled
Function Aborted
Auto Level Fail
SETTING THE ZERO POINT
LCD TOUCH PAD
• Manually run the jacks to level the unit. This is
best achieved by placing a level in the center
of the unit and leveling it both front to back
and side to side.
• Once the unit is level, turn off the touch pad.
• With the touch pad off, press and release the
“FRONT” button 5 times and then press and
release the “REAR” button 5 times.
• The touch pad will flash and beep and the
display will read “ZERO POINT CALIBRATION
ENTER to set, Power to Exit”.
• To set the current position as the zero point,
press “ENTER” button.
• LCD reads “Zero point stability check”.
• LCD display will read “Zero point set
successfully” once process is complete.
• The system will set this point as its level state
and the touch pad will turn off.
15
16