3
lippert.com 432 LIPPERT (432-547-7378) Rev. 10.19.21
Tire Linc
®
Tire Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003848
Installation of Repeater Dock
Install Tire Linc on a non-prepped trailer as follows:
NOTE: Non-prepped trailers do not have a repeater dock
installed; prepped trailers do. If a repeater dock is installed,
go to Installation and Setup section.
1. Locate a mounting area inside the trailer that allows
connection of the Tire Linc repeater dock (Fig.1A) to the
unit’s power source without creating a strain on the
completed connection.
NOTE: Connecting Tire Linc to a power source past the
disconnect will turn off the Tire Linc system if the power
source is turned off during transport.
NOTE: The Tire Linc repeater dock MUST be
mounted vertically.
NOTE: Film covering the repeater posts MUST remain
in-place until the repeater is installed.
2. Repeater dock mounting MUST be located in the
closest compartment to the tow vehicle, e.g., the front
compartment, that is free of any metal or obstructions that
could interfere with the signal and hinder reception.
3. Vertically orient the repeater dock and secure it to the
wall with two (non-supplied) #8 x ¾” self-tapping pan head
screws (Fig.1B).
Fig.1
B
A
C D
Resources Required
• OneControl
®
app
• Cordless or electric drill or screw gun
• Appropriate drive bits
• #8 x ¾” self-tapping pan head screws
• Wire strippers
• Appropriate electrical connectors
4. Make sure power to the trailer is off, then connect the
repeater dock’s red power wire (Fig.1C) and black ground
wire (Fig.1D) to system power and ground as follows:
A. If necessary, use wire strippers to expose enough bare
wire to make a good connection.
B. Use appropriate electrical connectors to create good
connections.
C. Make sure there is a 15A maximum circuit protection
placed in-line between the power supply and the
repeater dock.
To Next Page
Loading...
