Lippert Tire Linc 2020106863 - Sensor Pairing Procedure; Vehicle and Trailer Configuration; Sensor Pairing Sequence by Axle Type

6
lippert.com 432 LIPPERT (432-547-7378) Rev. 10.19.21
Tire Linc
®
Tire Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003848
7. Select a vehicle class (Fig.8) and tap CONTINUE.
8. Select a vehicle and tap FINISH (Fig.9A).
Fig.8
Fig.9
A
A
B
C
D
E
F
front
rear
Stem Sensor Pairing Sequence
The pairing sequence for stem sensors (Fig.10) is as
follows:
1. SINGLE AXLE: Stem sensors for a single axle trailer
MUST be paired in the following order: Left Front (Fig.11A),
Right Front (Fig.11D).
2. DOUBLE AXLE: Stem sensors for a double axle trailer
MUST be paired in the following order: Left Front (Fig.11A),
Left Rear (Fig.11B), Right Front (Fig.11D), Right Rear (Fig.11E).
3. TRIPLE AXLE: Stem sensors for a triple axle trailer
MUST be paired in the following order: Left Front (Fig.11A),
Left Middle (Fig.11B), Left Rear (Fig.11C), Right Front (Fig.11D),
Right Middle (Fig.11E), Right Rear (Fig.11F).
Fig.10
Fig.11