8
lippert.com 432 LIPPERT (432-547-7378) Rev. 10.19.21
Tire Linc
®
Tire Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003848
D. After the sensor has been found, the app will indicate
the next tire sensor to be paired (Fig.14B).
3. Repeat steps 2B–D until all sensors are
learned (Fig.15).
4. Tap the Finished button (Fig.15A) to exit TIRE
PRESSURE Sensor Conguration mode.
Tapping Finished exits configuration mode and redisplays
the TIRE PRESSURE screen. Do NOT tap the Learn
Sensors button again. Doing so resets Tire Linc into
configuration mode, which requires uninstalling the
stem sensors.
A
Fig.14
Fig.15
NOTE: To exit learn mode, tap the back arrow and the
sensors will not be forgotten.
NOTE: When learning has been completed, the low and
high pressure limits of the tires are estimated at +/- 20%
of the last received sensor data. Make sure sensors are
not removed during the learning process or the pressure
limit values will be incorrectly estimated. Pressure and
temperature limits can be set through the app after
learning has been completed.
NOTE: If installing the optional lock nut as a theft deterrent,
loosen stem sensor slightly and hand tighten lock nut against
the sensor. Using wrench provided in kit, hold lock nut in
position and hand tighten stem sensor against lock nut.
A
B
To Next Page
Loading...
