4
lippert.com 432-LIPPERT (432-547-7378) Rev: 09.29.21
Tire Linc
®
AU
Tyre Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004069
Installation and Setup
1. Locate and remove lm cover from repeater
dock (Fig.2A)�
NOTE: The film cover should only be removed when ready
to install the repeater�
2. Snap the repeater (Fig.2B) into the repeater dock (Fig.2C)�
NOTE: The repeater dock is keyed and the repeater can
only be snapped in one way�
Fig.2
3. The repeater will power on, lighting up the Status LED
(Fig.2D), blinking to indicate the repeater has power�
4. If the Status LED does not light up, check the in-line
fuse to the dock to ensure the dock has power�
5. Use the small tip of a tool or tip of a pen and push and
hold for ve seconds, then release the Pair Mode button
(Fig.2E)� The Status LED will turn on solid for one second,
then blink twice to indicate it’s in pairing mode�
Connect OneControl BT App to Repeater
1. Download the LCI OneControl BT app for either an iOS
or Android smart phone�
2. After the LCI OneControl BT app has been downloaded,
tap the OneControl BT icon (Fig.3A) to launch the app�
Fig.3
Fig.4
3. Read and accept the License Agreement (Fig.4)� Tap I
Accept button to continue�
A
C
A
B
D
E
To Next Page
Loading...
Need help?
General
