15
lippert.com 432-LIPPERT (432-547-7378) Rev: 09.29.21
Tire Linc
®
AU
Tyre Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004069
Troubleshooting
Remove Stem Sensor to Change Battery
Removal of the stem sensor battery can be completed with
the included stem sensor tool� The stem sensor tool, which
is taken apart to utilize, is comprised of two pieces molded
to match the tops and bottoms of the stem sensors� Slightly
rotate the pieces opposite of each other and then carefully
pry them apart to separate� One piece is used on top
of the stem sensor and one piece of the tool is used on
the bottom�
If the stem sensor batteries fail, replace them as follows:
1. Remove stem sensor from tyre stem�
NOTE: If using the optional lock nuts as a theft deterrent,
use the supplied wrench to hold the lock nut while
unscrewing the sensor from the tyre stem�
Changing Units of Measure
To change the units of measure—to/from Imperial/Metric—
go to the TYRE PRESSURE screen:
1. Tap the Settings icon (gear) (Fig. 9B)�
2. From the SETTINGS screens, tap the Units option�
3. The SETTINGS screen will display the current units of
measure�
4. Tap the arrow right of the Units setting�
5. On the TEMPERATURE SCALE window, tap the
desired unit of measure—°F–Fahrenheit or °C–Celsius�
NOTE: Unit of measure for temperature and pressure
(psi/kPa) will change according to the selection made�
6. Tap the back arrow above the screen title to return to the
SETTINGS screen�
NOTE: Displayed units of measure will change to match
the newly selected units�
7. Tap the back arrow above the screen title to return to the
HOME screen�
2. Using the stem sensor tool with a piece on top and a
piece on the bottom of the stem sensor, unscrew the top
cap of the stem sensor to expose the battery�
3. Replace battery with CR1632 3V lithium coin battery�
NOTE: Replacement batteries are not included�
4. Replace supplied stem sensor O-ring when
replacing battery�
Missing Stem Sensor
If a Stem Sensor becomes loose or is missing from a tyre,
the readout button (Fig. 20A) will be grayed out� Tighten the
loose sensor or replace with new�
Factory Reset
In the event a wrong caravan type is chosen or if there is a
new caravan configuration, the settings can be reset�
1. Press and hold the pair button on the repeater for
approximately 10 seconds�
2. Continue holding the button until there is one long red
blink followed by four red blinks�
3. Release button�
No Power
If system is not working, check the in-line fuse to the
repeater dock to ensure the dock has power�
Learn Sensors Procedure Resets System
Do NOT tap the Learn Sensors button� Doing so resets
Tire Linc into configuration mode, which requires
uninstalling the stem sensors�
To Next Page
Loading...
