To Next PageTo Next PageWhat to do if the Lissmac DTS 901-V Saw motor does not start?
If the motor of your Lissmac Saw doesn't start, there are several potential causes. First, check the mains cable for any issues. If the cable is fine, the problem might be a faulty motor or switch, which requires a trained technician to correct.
Why does my Lissmac DTS 901-V motor stop while sawing and then restart?
If your Lissmac Saw motor stops during operation but restarts after a pause, it could be due to several reasons. You might be feeding the material too quickly, so try cutting with a slower feed. Alternatively, the saw blade could be dull; try resharpening it by making 10-15 cuts in sand-lime brick. A worn saw blade (pad below 2 mm) could also be the culprit, in which case you should replace it.
General
