What to do if the Lissmac DTS 901-V Saw motor does not start?
If the motor of your Lissmac Saw doesn't start, there are several potential causes. First, check the mains cable for any issues. If the cable is fine, the problem might be a faulty motor or switch, which requires a trained technician to correct.
Why does my Lissmac DTS 901-V motor stop while sawing and then restart?
If your Lissmac Saw motor stops during operation but restarts after a pause, it could be due to several reasons. You might be feeding the material too quickly, so try cutting with a slower feed. Alternatively, the saw blade could be dull; try resharpening it by making 10-15 cuts in sand-lime brick. A worn saw blade (pad below 2 mm) could also be the culprit, in which case you should replace it.
What to do if Lissmac Saw blade is blocked?
If the saw blade of your Lissmac Saw gets jammed while cutting, switch off the machine and carefully remove the saw blade from the stone.
Why is there no water in my Lissmac DTS 901-V blade?
If there is no water reaching the saw blade of your Lissmac Saw, it could be due to a couple of reasons. The pump might not be running, which requires a trained technician. Alternatively, the lines could be plugged, so you should inspect and clear them.
How to fix wrong direction of Lissmac Saw?
If your Lissmac Saw is running in the wrong direction, it's likely due to incorrect motor polarity. To correct this, rotate the phases in the connector plug.
To Next Page
General
