Lissmac DTS 901-V - Resharpening the Tool; Changing the Cooling and Lubricating Agent

-26-
5.4. Resharpening the tool
If the saw blade should loses its cutting quality after long working time, the saw blade can be
resharpened with a few cuts into sand-lime brick or similar material.
5.5. Changing the cooling and lubricating agent
Very dirty water reduces the service life of the water pump and saw blade. With heavy use,
change the water daily. Remove sawing sludge and clean the suction sieve of the pump.
 Drain the water by opening the GEKA water connection on the rear of the machine