-13-
1.5.4.10 Keep water sources handy for refilling the water tank. Water sources may not be connected
directly.
1.5.4.11 Do not pull the power plug when power is on.
1.5.4.12 Remove the water pump from the water tank if there is danger of frost. Already frozen water
pumps must be thawed out before turning on.
1.5.5. Moving the masonry saw
1.5.5.1 The masonry saw may only be moved when the saw blade is at a standstill.
1.5.5.2 Before leaving the operating position, the machine must be shut down and the saw blade must no
longer rotate. There is a danger of injury by a rotating saw blade.
1.5.5.3 The operator activates the parking brake directly after moving the machine.
The machine must be secured against rolling away.
1.5.6. Special work while using the machine
1.5.6.1 Follow all setup, maintenance, and inspection activities and schedules prescribed by the operating
manual, including all information about the replacement of parts / assemblies! These activities
may only be carried out by technical personnel.
1.5.6.2 Inform operating personnel before beginning special and maintenance work! Name a supervisor!
1.5.6.3 If the machine is turned off during maintenance and repair work, it must be secured against
unexpected application of power.
1.5.6.4 Before cleaning all openings in which no cleaning agent should penetrate due to safety and/or
functional reasons must be covered and glued. Electric motors, switches and plugs are especially
at risk. After cleaning, remove the covers/tape completely!
1.5.6.6 During service and repair work, always tighten loose bolt joints!
1.5.6.7 If dismantling is required for fitting, servicing and repair, the safety fittings must be remounted
and checked immediately following the service and repair work!
1.5.6.8 No rotating tools which have a maximum rotation speed smaller than the nominal speed of the
machine can be used.
To Next Page
Loading...
