-12-
1.5.3. Commissioning
1.5.5.1 The commissioning of the machine may only be carried out in transport position.
1.5.3.2 When inserting the saw blade, observe the running direction.
1.5.3.3 When inserting the saw blade, protect against sharp edges.
1.5.3.4 Ensure that the floor on which cuts are to be made fulfils load carrying capacities.. All obstacles
must be cleared away from the cutting area and make sure there is sufficient lighting.
1.5.3.5 At least once per shift check the machine for externally recognisable damage and deficiencies!
Any changes which occur (including operating behaviour) must be reported immediately to the
responsible post/person! If necessary, immediately stop the machine and secure it against restart!
Before starting cutting operation each day, you must check:
check condition of the saw blade
Check safety equipment for proper function
1.5.3.6 No rotating tools which have a maximum rotation speed smaller than the nominal speed of the
machine can be used.
Defective or broken tools must immediately be replaced.
1.5.4. Operation
1.5.4.1 Refrain from working in any manner that is questionable in regard to safety!
1.5.4.2 Take measures to ensure that the masonry saw is operated only in a safe, functional condition!
1.5.4.3 At least once per shift check the machine for externally recognisable damage and deficiencies!
Any changes which occur (including operating behaviour) must be reported immediately to the
responsible post/person! If necessary, immediately stop the machine and secure it against restart!
1.5.4.4 Immediately stop and secure the machine in case of malfunctions! Immediately correct
malfunctions! Electrical work may only be carried out by qualified electricians.
1.5.4.5 Only suitable and tested tools must be used.
1.5.4.6 The masonry saw is made exclusively for sawing mineral material, in the wet cutting method.
Sawing of wood, plastic or metal and other materials is not intended use.
1.5.4.7 It is forbidden to connect the machine to the power mains without GCFI protection in the mains
supply line or the junction box.
1.5.4.8 For protection before acceleration, the cutting process must be initiated into the material slowly
and in steps. Avoid any contact with the running tool.
1.5.4.9 It is prohibited to cut without the saw hood (Pos. 4). The operator must be protected by turning
parts.
To Next Page
