-19-
3. COMMISSIONING
3.1. Connections and operating materials
Connection of electricity
Allowable power source with working voltage of 400V, 32A must be available.
Operating material drive oil
The motors are filled with drive oil by the manufacturer.
Operating material water
The water tank may only be filled with water. This water is used when sawing as a cooling and
lubricating agent and is conveyed with a water pump to the saw blade.
3.2. Function and adjustable parts
Main switch (pos. 1)
The main switch consists of a star delta connection and is
used to start larger 3-phase motors with squirrel cage rotors
having a power of 4 kW and up. This prevents the triggering
of fuses and possible voltage drops due to the high starting
current with direct starting.
Emergency stop switch (Pos. 3)
The machine is switched off by activation of the Emergency
Stop switch. The power mains to the drive elements is
finally disconnected.
Power plug (Pos. 8)
The power plug can be locked by hanging in the receptacle
with a padlock.
3.3. Setting up the masonry saw
Note
Ensure that the floor on which the machine is used fulfils load carrying capacities. All obstacles
must be cleared away from the cutting area and make sure there is sufficient lighting.
Y
0
To Next Page
