DP-DL01D [EUM-E] 18
3.9 EDX to DALI Patch
The “EDX to DALI Patch” function is to make EDX commands able to control DALI devices.
You can use EDX scene control panel (ECP-110T, ECP-310) to recall the scenes of DALI ballasts.
By doing this, a DALI system can be integrated to EDX system.
Please refer “EDX to DALI System Diagram”.
1. Click “EDX to DALI” tab
2. You can patch/map DALI address to EDX zone/channel. Click “Save” to store the change.
EX: DALI address 05 is patched to EDX zone1/channel 1:
EDX’s zone1/ channel 1 command will control DALI address 05.
EDX’s zone1 scene command will trigger the corresponding scene in DALI devices whose address is 05.
To Next Page
Loading...