Path 1:
1. Press VCR Plus+ button to display the VCR Plus+
menu.
Path 2:
1. Press TIMER to display the Timer Record menu.
2.
Press ENTER to start a new setting, or press
to select a previous setting which you would like to
modify, then press
ENTER.
3.
Press to go to the ‘VCR Plus+’ button, then
press ENTER to display the VCR Plus+ setup menu.
..........................................................................................
1. Press number buttons (0-9) or to enter the
PlusCode number, then press
ENTER.
Details of the preset program will be displayed.
2. The ‘Preset Channel’ dialogue box will then appear,
if the DVD recorder fails to find information of a
corresponding channel. Press to enter the number
of channel which corresponds to the guide channel
number designated by the VCR Plus+ system, then
press ENTER.
To make use of the VCR Plus+ system for timer
recording, you need to match the GCNs (guide
channel numbers) used by the VCR Plus+ system
with the channel numbers shown on your TV, so that
the relevant information can be correctly assigned to
the programs you would like to record.
3. Set ‘Mode’ (recording mode) and ‘Repeat’ (recording
frequency) for the timer program.
Press
to select one of the setting, then press
ENTER to go to the sub-menu. Press to select,
then press ENTER to confirm your selection.
4. Follow step 6-8 in ‘Setting Timer Program [Date/Time
Mode]’ to complete the setting.
If you want to return to the Date/Time mode, press
to select ‘Date/Time Setting’, then press
ENTER. However, please note that all the settings
you have entered will be cleared once you exit the
present setup screen.
If you would like to delete a timer program set
previously, go to Timer Record menu, highlight
the bin icon located in the first column of the
entry you want to delete, then press ENTER.
Notice for Timer Recording
1. To stop a timer-recording session:
Press STOP to cease the timer recording. Please
note that it may take a few seconds before the
program is completely brought to an end.
2. To check the recording status while ‘Timer
Record’ is active:
Press DISPLAY to bring up the Timer Record
information on screen.
3. About the overlap of timer programs
1. Each time after you complete and save the
settings of a timer program, the DVD recorder
will check if this program overlaps with other
ones you set previously.
2. If the current timer program does overlap with
one or more than one programs, a window
asking if you would like to keep current setting
will appear.
3. If you select ‘Yes’, the screen will go back to
Timer Record menu. Under this circumstance,
the later program takes priority, which means
the DVD recorder stops recording the earlier
program at the start time of the later program.
4. If you select ‘NO’, the screen will go to the
setting page. You need to change or discard the
setting of this program.
To Next Page
Loading...
