Need help?Do you have a question about the LiteOn EVO 6000 and is the answer not in the manual?
Describes upright, horizontal, and transverse installation methods for optimal cooling.
Details required spacing for single drive installations to ensure airflow and wiring.
Illustrates spacing requirements for side-by-side drive installations for airflow.
Illustrates the basic wiring diagram for three-phase power input.
Illustrates the basic wiring diagram for single-phase power input.
Explains the function of each button on the VFD keypad for operation.
Provides a table mapping numbers and letters to LED display characters.
Configuration of access level and control method for parameter settings.
Details various reset options based on sequence control and voltage.
Instructions for performing auto-tuning for motor parameters.
Guide for manually entering V/F characteristic parameters.
Details for manually inputting motor rated current, speed, and other parameters.
Configures the VFD's operation mode (Keypad, Terminal, Modbus).
Details the function and type of various digital and analog input terminals.
Assigns functions to digital input terminals S1 through S6.
Configures 2/3-wire control modes and DI terminal delay.
Sets analog input signal type, gain, and voltage bias.
Defines how the drive stops: Ramp, Coast, or DC Braking.
Configures acceleration, deceleration, and fast stop times.
Describes relay outputs (R1A, R1B, R1C) and analog output (FM).
Assigns trigger conditions to Relay 1 for various operational states.
Addresses Closed Loop Torque and PM Motor control capabilities.
Answers questions on recommended fuses, voltage tolerance, and braking resistors.
Presents the main circuit diagram with component connections.
Explains RJ45 port, analog input/output terminals, and NPN/PNP mode.
To Next Page
General