1. Using a Phillips screwdriver (not
included) remove the screws and
battery compartment cover (1) located
on the burner module (K).
2. Install three (3) fresh AA alkaline
batteries (not included), making sure
the (+) and (-) ends face the proper
direction as indicated inside the
battery compartment.
3. Replace the compartment cover and
tighten the screws.
ON/OFFON/OFF
Tool required (not included)
6
1
Ready...let’s start!
Battery installation
MUST be completed
by an adult:
1.5V AA/LR03
1.5V AA/LR03
1.5V AA/LR03
BACK BURNER LIGHTBACK BURNER LIGHT
FRONT BURNER LIGHTFRONT BURNER LIGHT
K
K
Burner module will automatically
shut o after 10 seconds.
Press button to re-activate.
To Next Page
Loading...
