Livall MT1 - Operating Instructions - Start-Up; Start-Up Procedure

3
IV. Operating Instructions
(Please charge the battery before use.Some models of helmets are not equipped with
Bluetooth speakers. The helmets without Bluetooth speakers could not take & make calls, listen to music and hear voice prompts.)
Start-Up
POWER ON" " function button
Press the " " button for
3-to-5 seconds
You will hear a voice saying
"POWER ON".
This device is successfully
powered up when the rear lights
come on.
remote controller keys.)
One helmet can be connected to up to two LIVALL-authorized devices at the same time. After the handlebar remote
control is connected, press the "left" or "right" button to control the helmet’s corresponding indicator light.