Livall MT1 - Operating Instructions - Connections; Connecting for the first time; Replacing device

4
Two "beeps"
" " function button
Turn on the device, which should
be within 5 meters of the helmet.
It will automatically connect the
helmet.
Place a device that is already ON
near the helmet's main control.
After the connection is established, it
(The helmets without Bluetooth
speakers could not hear such voice
prompts. Please check the taillight to see
if the helmet is connected successfully.)
When the warming light ashes
and the helmet speakers emit two
"beeps", it indicates that there is a
device nearby requiring connection
to the helmet.
(The helmets without
Bluetooth speakers could not hear
such voice prompts.)
≤5m
2. Replacing device
Press the "
" button on the helmet
within 10 seconds after you hear
to the device.When pressing the
arrow left or right key on the bling
jet remote, the right or left turning
signal appears.
Two "beeps"