LivePure LP1700FAP - Operating the Remote Control; Replacing the Remote Control Battery

1. Power: Press ON/OFF on remote to power on. Press ON/OFF again to power off.
FIGURE 4.
2. Speed: To change the fan speed, press the SPEED button. A light will be on next
to the selected speed on the fan. Continue pressing the button
until the desired speed is selected. Choose from Low, Medium
and Turbo speeds. FIGURE 4.
3. Rotate: To turn rotation on or off, press the ROTATE
button. When rotation is turned off, fan will pause in the
exact position until the ROTATE button is pressed again.
FIGURE 4.
4. Timer: To set a timer, press the TIMER button. There will
be a light next to the selected speed. Continue pressing the
TIMER button until correct amount of time is selected.
Choose from 1, 2, 4 or 8 hour intervals. FIGURE 4.
5. Light: Press the corresponding button to select the
desired color of the accent light: WHITE, GREEN, PURPLE or
BLUE. Note: If accent light is on when fan is powered off, light will remain on unless
the LIGHT button is pressed once more. FIGURE 4.
Operating the Remote Control:
Operating Your Fan
Remote Control Operation
1. Turn over remote control. Press tab A toward the right
and pull. FIGURE 5.
2. Pull out battery holder B and replace the battery. Only
use the specied battery type (Lithium Button Cell
Battery CR2025). The battery must be installed with the
positive side facing up. FIGURE 6.
3. Insert battery holder B back into remote. FIGURE 7.
Note: Do not apply excessive force to battery holder.
Remove battery when not using for an extended period
of time. When disposing of used battery, please use the
correct method of disposal.
Replacing the Remote Control Battery:
Figure 7
3
Figure 5
1
A
Figure 6
2
B
Battery : Lithium Button Cell Battery (CR2025)
WARNING
Keep the lithium battery out of
reach of small children.
Small children may accidentally swallow it.
If swallowed, call your doctor immediately.
Figure 4
ON/OFF SPEED
TIMER ROTAT E
WHITE GREEN
PURPLE BLUE
6