To Next Page

To Previous Page

LM506 Quick Start Guide v1.1

Step 7: Installation complete

6 FCC Warning Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including

interference that may cause undesired operation

This equipment has been tested and found to comply with the limits for a

class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Installation and use of this device must be in strict accordance with the

instructions included in the user documentation provided with the

product. Any changes or modifications (including the antennas) made to

this device that are not expressly approved by the manufacturer may void

the user’s authority to operate the equipment. The manufacturer is not

responsible for any radio or television interference caused by

unauthorized modification of this device, or the substitution of the

connecting cables and equipment other than manufacturer specified. It is

the responsibility of the user to correct any interference caused by such

unauthorized modification, substitution or attachment. Manufacturer and

its authorized resellers or distributors will assume no liability for any

damage or violation of government regulations arising from failing to

comply with these guidelines.

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

LM Technologies LM506 User Manual

Questions and Answers: