To Next Page

To Previous Page

Note that the stylus may not move freely if the recorder is in the imprint section of its

operating cycle with the stylus pressed against the chart paper. In this case the

recorder chart motor should be operated for a few seconds until the imprint pressure is

released, or the imprint drive wheel (12) can be manually rotated. The chart paper can

be manually advanced by operating the manual paper feeding wheel (7) to set the

desired zero time position.

Questions and Answers:

Need help?

Do you have a question about the LMS 1 Series and is the answer not in the manual?

LMS 1 Series Specifications

General