6
Section 1
GENERAL DESCRIPTION
1.1 INTRODUCTION
The standard range of LMS cooled incubators comprises of nine models, all of
which are available with a range of optional extras to suit individual
requirements. A further two models, 410XAL and 610XAL, which have
special built in features, are also available. Details on request.
1.2 CONSTRUCTION
The outer case of all models in Series 1 and 3 is of sheet steel finished in
white stoved enamel. Foam insulation is used, to ensure maximum insulation
against external ambient temperature. The internal liner of models in Series 1
is of a high impact vacuum formed plastic with a minimum of crevices, and all
corners are radiused. Models in Series 3 have an unobstructed working space
fabricated from polished stainless steel complete with multi position plastic
moulded shelf supports, which allow the three white plastic coated steel
shelves to be randomly positioned to suit individual requirements.
All cooled Incubators within the LMS Series 1 and 3 range incorporate both a
door lock and magnetic gasket with all control features being set into a control
panel and positioned so as to minimise the risk of accidental alteration. Series
4 models have both a stainless steel exterior and interior and come with 5
stainless steel shelves (model 600) and 10 stainless steel shelves (model 1200).
1.3 TEMPERATURE CONTROL
The temperature control method utilises a controller offering digital selection
and readout of temperature.
1.4 COOLING
Cooling is provided by a hermetically sealed refrigeration system which can be
independently switched off for defrosting purposes, or for operation at
temperatures 10ºC or more above ambient. All LMS Cooled Incubators
comply with the latest CFC-free regulations.
1.5 AIR FLOW
A full air flow system is used. The airflow being at low velocity but high
volume.
Section 2
To Next Page
Loading...
Need help?
General
