“STORING” A OPTION CABLE’s HOOK
Some container handling OPTIONS have a cable,
with a hook, at the working end of the cable.
The roof-mounted cable reever (aka..the “2-10”
option), or a spooling drum winch option, or the
“1-2” Sling Lift are all “container handling”
OPTIONS that do have cables (aka..Wire Rope)
with Hooks crimped to the working end of the
cable.
Most often, on the route, this cable Hook is NOT in
actual usage and therefore it needs to be “stored
away” ... until the next time the Operator needs to
“lift/handle” a waste container (by hooking the
cable’s hook to the Container).
Always STORE any cable’s Hook ONLY in the
provided Bent Peg hook store(s). (This is a
“breakaway” style peg ... that Loadmaster will have
welded to the tailgate’ shell for store purpose).
The “bent peg” hook store is welded on “both”
sides of the gateshell for operator’s best
“convenience”.. storing the cable’s Hook at either
the left OR the right Bent Peg is the only correct
(safe-est) location to store the cable’s Hook.
Sec02-pg25
Bent Peg Hook
Store...store the Cable’s
hook ONLY (ONLY!) at
either the Right side Peg
or the Left Side Peg... do
NOT store the hook to
anything else
CABLE; allowing a bit of cable SLACK is
generally a recommended “technique”
PROPER HOOK STORE...
The BENT PEG hook store..
the ONLY correct hook
storeage location.
Alternative “correct” Cable Hook Stores...Right-side/
CurbSide.... these “EYES” can be used to Store the
Cable’s Hook, as a Alternative “hook store” location.
LEFT Hand Side’s “EYE” (on
Driver’s side)..a alternative
location to hook/store the cable’s
hook
Bent Peg Hook
Store...STORE cable’s
hook here (RH side)
To Next Page
Loading...