5
3. ATTACH TAG
Adhesive strips: Best used when attaching to a clean,
dry, hard, at surface. Peel off backing to attach.
Sticky tabs are not permanent but increase their bond
with time. Ideally leave for a minimum of 10 minutes.
Strongest bond after 24 hours. To remove insert at tool
under Tag and gently twist to prise off.
Key ring loop: Use to attach Tag to items such as key
ring, bags, mobile phones etc. Push loop through the
Tag hole and then pull ring through the loop.
Release button – Loc8tor will beep to conrm start of •
registration and status light will ash rapidly. Tag will
complete registration process.
Once registered Tag and Loc8tor will beep and ash •
once.
Repeat process for up to 4 Tags, assigning each Tag
to a different button. Each of the four Tags when being
located will beep differently to help identication.
To Next Page
Loading...