Need help?Do you have a question about the Lochinvar EcoShield SHW35-245CE and is the answer not in the manual?
General| Brand | Lochinvar |
|---|---|
| Model | EcoShield SHW35-245CE |
| Category | Water Heater |
| Language | English |
Provides immediate actions to take if a gas smell is detected, including safety precautions and who to contact.
Covers general requirements for flue system installation, including condensate management and material suitability.
Outlines requirements for safe and efficient flue gas dispersion, considering plume nuisance.
Provides specific minimum distances for flue terminal positions relative to building openings and features.
Refers to BS5440-1, BS6644, and IGE/UP/10 for detailed flue system recommendations.
Specifies that only Lochinvar M&G flue systems are approved for concentric/twin pipe configurations.
Highlights critical installation precautions, including flue gas temperature sensor fitting and complete flue system installation.
Explains condensate flow and the importance of flue system rise to prevent pooling and failure.
Describes C13 concentric horizontal flue systems, their specifications, and included components.
Provides step-by-step instructions for installing horizontal flue terminals, including cutting and sealing.
Details the installation procedure for C33 appliances, including roof flashing and terminal insertion.
Provides general installation guidelines and diagrams for concentric flue systems, including measurements.
Continues to display installation diagrams for concentric flue systems with detailed measurements and steps.
Addresses condensate drainage for C43 systems, emphasizing flue rise to prevent pooling and failure.
Describes C53 twin-pipe flue systems, their specifications, and components included in starter kits.
Shows general installation guidelines and diagrams for twin-pipe flue systems with various configurations.
Continues to show installation diagrams for twin-pipe flue systems with detailed measurements and steps.
Details the requirements for fitting flue terminal guards for horizontal terminals based on location and accessibility.
Lists components required to start installation for Type B23 conventional flue assemblies.
Provides C63 flue system specifications, including material, standards, and dimensions for twin-pipe and concentric systems.
Addresses condensate drainage for C63 systems, emphasizing flue rise to prevent pooling and failure.
Presents the main wiring diagram for the EcoShield™ water heater, showing electrical connections and components.
Shows the ladder diagram illustrating the control logic and electrical flow of the EcoShield™ system.
Details the sequence of operation during heating calls, including pump activation and fan control.
Shows the display states during different stages of the operation sequence, including ignition and modulation.
Lists essential general checks before lighting the appliance, ensuring safety and readiness.
Provides a step-by-step procedure for initial lighting of the water heater, including gas and fan sequences.
Details combustion figures for natural gas and advises against tampering with gas/air ratio assembly.
Outlines the mandatory procedure for converting the appliance from natural gas to LPG by a qualified person.
Details the specific procedure for converting SHW35-245CE to SHW86-410CE models for LPG operation.
Details the specific procedure for converting SHW116-410CE models for LPG operation.
Illustrates the conversion procedure for SHW116-410CE models, including orifice insertion.
Details the specific procedure for converting SHW146-410CE models for LPG operation.
Illustrates the conversion procedure for SHW146-410CE models, including orifice insertion.
Details LPG pressure adjustment and combustion checks, including CO2 and CO figures.
Provides LPG combustion figures and advises contacting technical support if they are out of range.
To Next Page