Fig. 4

Digital 2835 Lever

*with Passage Function

Installation Instructions

No. Part Name 2835

Outside Body

Inside Body

Lever Handle

Rubber Trim Plate

Strike Plate

Morsed Striker

Machine Screw M4 x 40mm

Machine Screw M4 x 30mm | 50mm

Wood Screw M4 x 16mm

Extra Code Tumblers (Red)

Extra Non-Code Tumblers (Blue)

Adjustable Latch 2 3/8” - 2 3/4”

Support Pin

Tweezers

Hex Bolts

1 | 1

Spindle

7 1

Allen Wrench

8 1

Step 1: Change User Code/Combinaon (OPTIONAL)

To change user code/combinaon, see instrucons on reverse side.

Step 2: Prep Door for Installaon with Template

Place template (supplied) on door and fold along door’s edge.

Mark holes for 2 3/8” or 2 3/4” backset. Drill holes as instructed.

Note: For pre-prepped 2 1/8“ doors, you only need to drill top hole.

Step 3: Idenfy Door Handing

Right-Hand Doors – From exterior of door, hinges are on right-side (Fig. 1).

Le-Hand Doors – From exterior of door, hinges are on le-side (Fig. 2).

For Right-Hand Doors: Install Support Pin (#15) in posion ‘A’.

For Le-Hand Doors: Install the Support Pin (#15) in posion ‘B’.

Now, install/screw Hex Bolts (#17) into the top and boom as shown.

Step 4: Install Lever Handles

Using Allen Wrench (#8), install levers to the inside and outside bodies.

Secure with set screws.

Note: Levers should point towards the door hinges.

Note: The 2835 is equipped with a built-in slip clutch lever handle to prevent

damage in the event of an aempted forced entry.

If lever handle is in posion shown (far right), pull lever back to desired posion.

Step 5: Adjust Latch (if necessary) and Install

Adjustable Latch (#14) is preset to 2 3/8” backset.

To adjust: Remove plasc plug, slide to 2 3/4”, and replace plasc plug as shown (Fig. 5).

Insert Adjustable Latch (#14) into the door.

Secure with two (2) Wood Screws (#11).

Fig. 3

Fig. 5

Connued on Reverse Side

RIGHT HAND LEFT HAND

Support Pin

1. Remove Plastic Plug

2. Move/Slide to 2 3/4”

3. Replace Plastic Plug

IMPORTANT INFORMATION ABOUT YOUR DIGITAL 2835

1. When the door is closed, the system locks automacally.

2. From the inside, unlock using the Lever Handle.

3. From the outside, unlock by pressing ‘C’ (CLEAR), followed

by your User Code.

4. The 2835 is equipped with a PASSAGE FUNCTION,

allowing you to leave the door unlocked.

-To enable the passage funcon:

Press ‘C’ (CLEAR), then ‘Y’ (PASSAGE), then enter User Code.

-To disable the passage funcon:

Press ‘Y’ (PASSAGE), followed by ‘C’ (CLEAR).

-To disable the passage funcon PERMANENTLY:

Remove the ‘Y’ (PASSAGE) tumbler, leaving that slot empty.

IMPORTANT: Always press and hold the ‘C’ Buon when

removing and inserng Tumblers. Refer to ‘How to Change

Code’ instrucons on reverse side.

* *

Slip Clutch

LOCKEY 2835 - Installations Manual

Other manuals for LOCKEY 2835

Related product manuals