LOG Cube - User Manual

Questions and Answers

J
Jeremy JohnsonJul 27, 2025
Why is there no sound coming from my LOG Cube?
- J
  John RossJul 28, 2025
  Several factors could be causing the lack of sound from your LOG Speakers. First, check if mute mode is active and deactivate it by pressing the “Mute“ or “Volume up +“ button on the remote. Also, ensure the audio source is close enough to the audio system. Verify that you are connected to “PROLOG“ via Bluetooth, AirPlay® or UPnP/DLNA; disconnect and reconnect if needed. Confirm that the power plugs of both the CUBE and the PROLOG are securely connected to the power outlet. Finally, check that the audio source volume is not muted and gradually increase it.
C
Christine HullAug 1, 2025
What to do if LOG Speakers audio playback has recurring short failures?
- B
  Brett BensonAug 1, 2025
  If you're experiencing recurring short failures of audio playback with your LOG Speakers, the issue might stem from a poor connection to the audio source via Bluetooth or WiFi. Ensure the audio source is close to the PROLOG and free from interference. Try reducing the distance between the audio source and the speaker, or restart both your PROLOG and your Bluetooth source. For WiFi connections, reduce the distance from your audio source to your PROLOG. Restart your PROLOG and your AirPlay® or UPnP/DLNA source. If issues persist with WiFi, consider contacting a wireless network specialist.
S
Shawn AustinAug 6, 2025
What to do if the signal from my LOG Speakers is too quiet?
- G
  Gordon CollinsAug 6, 2025
  If the signal from your LOG Speakers is too quiet, the input signal might be too low. Try increasing the volume at the audio source. Also, check if the volume has been set too low with the remote control; if so, increase it by pressing the “Volume up +“ button.
R
Robin WolfeAug 12, 2025
What to do if the signal from my LOG Speakers is too loud?
- A
  Alice LaneAug 12, 2025
  If the signal from your LOG Speakers is too loud, it could be due to a high input signal. Try decreasing the volume at the audio source. Also, check if the volume has been set too high with the remote control and decrease it by pressing the “Volume down -“ button.
T
Timothy RiosAug 16, 2025
How to fix simultaneous playback of multiple audio signals on LOG Cube Speakers?
- K
  Keith ChristianAug 16, 2025
  To resolve the simultaneous playback of multiple audio signals on your LOG Speakers, stop playing any unwanted sources. This includes sources like analog input, digital input, Bluetooth, AirPlay®, or UPnP/DLNA connected to your PROLOG.
L
Lori WuAug 22, 2025
What to do if PROLOG Speakers are not visible on the network?
- L
  Lisa PrestonAug 22, 2025
  If your PROLOG Speakers are not visible on the network, it may be due to connection problems between the PROLOG and your home network. Try disabling the WiFi on your home network and restarting the PROLOG. This will allow the PROLOG's autonomous network to initiate a new configuration.