Sound & Electronics LOG GmbH | Sankt-Georgen-Gasse 7, 8020 Graz, Austria | ofce@logaudio.com | www.logaudio.com
2
CUBE
User Manual
Integrate PROLOG 2 into your home network
The easiest way to integrate the PROLOG 2 into your home network is to use a Ethernet connection with
your network. Use the Ethernet connection on the back of the device. Your PROLOG 2 will appear as a
DLNA and AirPlay® speaker in your network after a few seconds.
If you want to connect the PROLOG wirelessly to your own network, you can do this with the “AirLino®“-App:
1. Install the AirLino® app, available for download from the Apple App Store or Google Play Store.
Note: Alternatively, a conguration program for Windows can also be downloaded and installed at https://www.
lintech.de/support/downloads/wlan-musikempfaenger/ for conguration via a computer.
2. Enable WiFi on your device
3. Search for the WiFi network “PROLOG“ and connect to it
Note: If your PROLOG is already integrated in your home network, you need to connect to your home network to
change the settings.
4. Open the AirLino® app, nd your device and connect to it.
5. Select your home network and enter the correct WiFi password. The AirLino® app will now try to connect your
PROLOG to your home network.
Note: If the device is not ready after 60 seconds, an error might have occurred. Please check if you have entered
the correct network password and follow the previous steps again. In some cases it is useful to turn PROLOG off
for about 10 seconds and go through the steps again.
6. After the successful setup your PROLOG will be visible on your network. You can then see the device in the audio
streaming devices.
7. Enjoy the music through your CUBE speakers.
Note: Please make sure that the WiFi connection and the signal are stable and strong enough to manage high quality
audio signals in your home network. Low quality WiFi routers might cause problems. Please contact a wireless network
specialist if problems occur.
Changing PROLOG 2 device name
1. Install the AirLino® app, available for download from the Apple App Store or Google Play Store.
Note: Alternatively, a conguration program for Windows can also be downloaded and installed at https://www.
lintech.de/support/downloads/wlan-musikempfaenger/ for conguration via a computer.
2. Enable WiFi on your device
3. Search for the WiFi network “PROLOG“ and connect to it
Note: If your PROLOG is already integrated in your home network, you need to connect to your home network to
change the settings.
4. Open the AirLino® app, nd your device and connect to it.
5. In the settings of the selected device, you can now assign your own name to your PROLOG so that it will be easier
to recognize later.
6. Your PROLOG is now visible with its own name as AirPlay® and UPnP/DLNA receiver.
7. Enjoy the music through your CUBE speakers.
AirLino®-App
To Next Page
Loading...