EasyManuals Logo

Logik L612WM12 User Manual

Logik L612WM12
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
Theres not much foam. • This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
• The amount of foam can vary, depending on the temperature, level
and softness of your water.
• You may not be using enough detergent.
• You may be using a reduced-foam type of detergent.
• Heavily soiled laundry can reduce the amount of foam.
• Larger loads of laundry can also reduce the amount of foam.
Theres a lot of foam • The amount of foam can vary depending on the temperature, level
and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excess foam.
Fabric softener overflows • You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer too
sharply.
Theres a residue of powder
detergent at the end of the
wash
This can happen if you’ve put powder detergent directly into the drum –
you must put it in the detergent drawer.
Theres an unusual noise or
vibration
• Check that theres nothing metal in the drum.
• Make sure the transit bolts used in transportation have been
removed.
• Check that the washing machine feet have been levelled correctly.
• Check the washing machine is on a flat, stable surface.
Theres a noise when the
water drains away
This is normal, it’s the pump starting and stopping.
The electricity supply cuts
out while the washing
machines on
The washing machine will stop (do not open the door if the machine is
full of water). When the power comes back on, the washing machine will
continue the programme.
The water supply is
disrupted
When the water comes back on, it may be impure at first.
You’ll need to disconnect the water-supply hose and drain any impure
water through the tap before using your washing machine again.
Remember to re-connect the water supply hose first.
Excessive foam in the
detergent drawer
Press the Start/Pause button. Change the programme to the Rinse
selection to manually rinse and drain the drum. Use the correct amount
of detergent next time.
L612WM12_IB_120529_Annie.indd 22 12年5月29日 下午2:46

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik L612WM12 and is the answer not in the manual?

Logik L612WM12 Specifications

General IconGeneral
BrandLogik
ModelL612WM12
CategoryWasher
LanguageEnglish

Related product manuals