21
Hints and Tips
Problems Solutions
Buttons don’t work • Child lock is activated. Deactivate the child lock function.
• The washing machine is operating a wash programme.
• The Programme Dial was turned to a different programme.
Door doesn’t open • Door lock may be active.
• The water temperature or level could be too high.
If you start a wrong
programme accidentally.
First press Start/Pause button or turn the Programme Dial to 0(Off)
position. Secondly turn the Programme Dial to the correct programme,
spin speed or optional function you want. Press the Start / Pause button
to start the new programme. (Note: We suggest that you do not change
the programme after the machine has been running for 3 minutes.)
Unusual odour. • Rubber parts and the motors may give off a smell when you first start
using the washing machine, but this goes away over time.
• You should wash the drum once a month.
You can’t see any water. This is normal: The water level is below the window.
There’s no water going into
the washing machine.
• The water tap might be turned off.
• The water hose or water-supply hose may be frozen.
• Your water supply may be disrupted.
• The water-supply valve filter may be clogged.
There’s only a small amount
of water.
• If you have paused the programme and you restart, the washing
machine may drain some water.
• Don’t pour water in through the door.
Water adds up during
washing.
This is normal: water is supplied automatically as the level lowers, and
with heavy loads the water may fill up repeatedly.
The washing machine does
not spin.
• The rinse hold may be active. Press the Rinse Hold button to
continue.
• If a small load is in the washing machine, it may be detected as an
unbalanced load and may stop spinning after a number of attempts.
Select the manual spin.
There’s no water going into
the washing machine during
rinse operation.
Before rinsing, the washing machine spins to drain water remaining from
the wash. The water will fill up after that.
During the spin-dry, the
drum stops and rotates
several times.
This is normal. The washing machine has detected an unbalanced load
and is trying to correct it.
Foam and water remain in
the door or door seal.
Although foam and water may remain, it does not have any influence on
the performance of a rinse.
Spin starting is repeated. This is normal. Although spin starting may be repeated, it is a function
made to spin quietly.
L612WM12_IB_120529_Annie.indd 21 12年5月29日 下午2:46
To Next Page
Loading...
Need help?
General
