31
Wash Setting
Standard Washing
1. Pull the door handle and put the laundry in the
drum. (Refer to Preparation to sort your laundry
before it goes into the drum.) Make sure no washing
gets caught in the door.
2. Close the door.
3. Add detergent into the detergent drawer. The
quantity of detergent will depend on the amount
of laundry, the degree of soiling and the water
hardness. Use the amount of detergent suggested
on the packaging.
4. Turn the Programme dial to select a wash
programme.
5. Change the temperature if desired.
6. Press the Start / Pause button to start the washing.
7. The End LED will be lit when the programme is
complete.
Before First Use
Before washing your clothes for the first time, run a full wash programme first:
1. Connect the machine to the mains power supply and the water supply.
2. Put a small amount of detergent in the detergent drawer. Close the drawer.
3. Select a wash programme.
4. Press the Start / Pause button.
• If the door is locked and you switched the washing machine off - or if there’s a
power cut - it will stay locked for 1 minute. If the machine is full of water, do NOT
open it.
Removing Washing (Once programme is nished)
Door remains locked for 1 minute after wash stopped.
90°C
60 min
60°C
40°C
Eco 20°C
• Open the washing machine door and remove your washing.
• Remove any foreign objects to avoid risk of rusting.
• Leave the door and detergent drawer open so that residual water can evaporate.
L612WSM16E_IB.indb 31 21/03/2016 16:04
To Next Page
Loading...
Need help?
General
