10
If the Flame Is Irregular
If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
• Clean and dry.
• Positioned correctly. See ‘Replacing the Burners’.
• Also see 'Hints and Tips'.
Using the Hob
The control has 3 positions: 0, maximum ( ) and minimum ( ). After you have ignited the burner at the
maximum position (
), you should adjust the flame length for cooking between the maximum ( ) and
minimum (
) flame positions. You must not cook with the control between the maximum ( ) and 0 positions.
Flame failure probe
Ignitor
If the Burner Does Not Light
If the burner does not light, check that:
• The cooker is switched on at the mains supply to enable the ignition circuit to work.
• The gas is turned on.
• You have held in the control for at least 5 to 10 seconds.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them gently
with a small nylon brush such as a toothbrush as shown below.
Never operate the ignition without the burner parts in position. You may damage the electric
ignition.
* All images are for indication only; please refer to your individual unit for actual item.
Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 10Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 10 14/12/2020 16:0714/12/2020 16:07
To Next Page
Loading...
Need help?
General
