9
water mains
Y-Adaptor
(not included)
safety water supply hose
Connect
to another
appliance if
required.
You may use a Y-adaptor (not
included) for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-adaptor is available
from most DIY stores.
Before connecting to the waste
pipe, make sure to check the
waste pipe and remove any
stopper or blockage inside,
otherwise the unit may not be
able to expel the waste water
properly.
14. Insert the toe panel to the dishwasher.
15. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualied plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE SETS
MUST NOT BE RE-USED. The water pressure
from the water mains needs to be at a
minimum of 0.04 MPa and a maximum of
1.00MPa.
16. Connect the water supply hose. You can
connect the water supply hose to the
mains water, or depending on the type of
tap you have you can purchase an adaptor
to connect the hose directly onto your tap.
17. Connect the drain hose. The drain hose can
be placed into your sink, or connected to
the waste pipe.
LID60W20_IB_RC_Final210603.indd 9LID60W20_IB_RC_Final210603.indd 9 3/6/2021 5:42 PM3/6/2021 5:42 PM
To Next Page
Loading...
Need help?
General
