Logik LOG32LW782 User Manual

English - 18 -
Initial Settings
When the TV set is operated for the first time,
the IDTV turns on first.
Because this is the first time the TV is used, there
are no channels stored in the memory and the
following message appears on the screen:
Please ensure aerial is plugged in.
Do you want to start automatic search?
Yes
No
• To start installation process, select “Yes”,
to cancel select “No”.
• To select the “Yes” or “No” option, highlight
the item by using
or buttons and press
the
OK button.
The IDTV will automatically tune to the UHF
transmission channels 21 to 68, searching
for digital terrestrial TV broadcasts and
displaying the names of channels found. This
process will take about five minutes. To cancel
searching, you can press the M button at any
time during the process.
MENU
BBC ONE
BBC TWO
BBC CHOICE
Searching UHF channels 30. Please wait. This will take a few minutes
Cancel search
AUTOMATIC SEARCH
Channels:
12 %
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen:
Yes
Do you want to search for
analogue channels?
No
To search for analogue channels, select
“Yes”. TV switches to the analogue TV mode.
The menu below is displayed to search for
analogue channels:
Country
Language
UK
Ok
Cancel
PLEASE CHECK ANTENNA CABLE
AUTO PROGRAMMING SYSTEM
TXT Language
Select your Country, Language and Text
language
by using or and

/

buttons.
Press
OK or RED button to continue. To cancel,
press the
BLUE button.
For more information on this process, see
“Install Menu” section.
NOTE: For proper functioning of digital teletext
in DTV mode, you should set
country
as UK in analogue AUTO PROGRAM.
General Operation
Pressing the TV/DTV button at any time while
watching television programmes will switch
the TV set between the digital terrestrial
television broadcasting and its normal
analogue broadcasting.
Information Banner
• Whenever you change channel, using the P-
/ P+ button or the numeric buttons, the TV
displays the broadcast picture along with an
information banner at the bottom of the
screen. This will remain on the screen for
approximately three seconds.
• The information banner can also be
displayed at any time while watching TV by
pressing the
button on the remote
ENG-32782W-1050 UK-32INCH-17MB12 UK IDTV-(2 HDMI-3D PAN-WO SVHS-BASIC PIP-WO VGA)-C2-50117669.p6508.10.2007, 11:0218

Logik LOG32LW782 Specifications

General

Brand	Logik
Model	LOG32LW782
Category	TV
Language	English