Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 11
Before use
Before using the nursing bed, take the following measures.
Read the instructions for use before using the nursing bed.
Connect the nursing bed to 120–240 V ~, 50/60 Hz voltage. Check
section 4.1 of the manual for the safe use of the power cord.
Make sure that the power cord is not tied to anything. If the power cord
is tied to something, it may break when the bed is moved.
When the bed is stationary, always keep the wheels locked.
Make sure that the surroundings of the device are safe. Make sure
there is adequate room around and above the device. Make sure there
are no sharp corners or potentially hazardous objects around the
device.
Make sure that the side rails work flawlessly and lock in the top
position.
If the bed is placed against the wall, side rail facing the wall must be
raised up (Risk of squeezing).
Do not place the bed on a sloped floor. Unlocking the wheels on a
sloped floor may cause a hazardous situation.
Make sure that all the movements of the bed work properly.
Clean the product as instructed before use.
To Next Page
Loading...
