Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 24
Image 32. Adjustable side rail
6.11 Moving the bed into transport position
In the transport position, the Lojer Modux nursing bed can fit through small
spaces and takes up little storage room.
1. Remove the side rails and any accessories (see section 6.4).
2. Make sure there is space around the bed.
3. Lock the wheels at the end to which the power cord attaches (see section
6.5.1 and 6.5.2).
4. Plug in the power cord and adjust the sleeping surface, back section and
foot section to their lowest position (see image 33).
5. Remove the locking hooks from their holders around the middle joint on
both sides of the bed and pull them out. Move the locking hooks to lock
the back section on both sides by pushing the locking hooks pegs thru
holes in sideframe and back section. Make sure that the handedness of
the locking hooks remains correct to make sure the hooks doesn’t open
during transportation (see images 17,19 and 33).
Image 33. Resetting adjustments and locking hook peg in the locking hole
of the back section
To Next Page
Loading...
