Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 6
If patients' family member, visitor or other layperson is allowed to use
the functions of the bed, their capability to use the bed safely must be
ascertained and they must be fully instructed in the safe use of the
functions. If necessary, lock the movements of the bed from the hand
control unit.
If safety precautions are applied to ensure the safety of patient, e.g.,
side rails must always be in raised position, make sure that family
member, visitor or other layperson does not remove these safety
precautions from use. Instruct family member, visitor, or other layperson
about safety precautions and if necessary, supervise that the
instructions are followed.
4.1 Safe use of the power cord
Observe the following safety instructions when handling the power cord.
Never tie the power cord to the bed because a lifting movement may
cut it. Mains plug is considered as disconnecting device. Make sure that
you can quickly disconnect the power cord in case of emergency.
Check that the power cord travels away from the head of the bed and
that the cord does not get wedged into the mechanism during raising.
The socket should always be located at the same end where the power
cord attaches to the bed, max. 2 m away from the head of the bed.
Always disconnect the power cord before moving the bed. Make sure
that the cord is not crushed between the bed's structures or castors.
If the power cord is cut or damaged, disconnect it immediately. Risk of
electric shock.
Make sure that there is enough space between the socket and the bed
and that raising the bed will not damage the socket, the plug or the cord.
To Next Page
Loading...
