To Next PageTo Next Page
Need help?Do you have a question about the Loma Superscan Micro ISC and is the answer not in the manual?
Specifies batch length in hours or packs, accumulating statistics before reset.
Synchronizes batch start to a specific time for hourly statistics, or disables facility if set to 00.00.
Selects batch interval units as TIME or PACKS. PEC must be fitted for PACKS.
Sets date and time for stamping contaminant, fault, and error logs, and printed reports.
Accesses calibration options: Full Calibration, Update Calibration, or Man Setup.
Changes the currently running product by selecting from available options.
Clears all entries from the contaminant log.
Clears run errors, turning off error LED and relay if the error is no longer occurring.
Clears system faults, turning off fault LED and relay if the fault is no longer active.
Adjusts compensation value, automatically derived during calibration, if advised by LOMA.
Displays machine configuration details, typically adjusted during commissioning.
Allows viewing, clearing, and reporting of contaminant log entries.
Transmits contaminant log details down the serial link, typically to a printer.
Sets the time for a contaminated product to travel from detector to reject point or PEC.
Disables the reject device so no product is rejected, even if contaminated.
Configures detector for 'Dry' mode, useful for high vibration applications.
Sets the time or distance the reject device is activated for contaminated products.
Re-enables the reject mechanism after it has been disabled.
Transmits the contents of the Run Error log down the serial link, typically to a printer.
Identifies metal test samples exceeding a specified false threshold value.
Transmits the contents of the System Fault log down the serial link, typically to a printer.
Sets the ferrous test wand size, prompted for during PV Test.
Defines the length of the product along the conveyor, allowing for skew.
Calibrates the detector for optimal performance using representative product samples.
Shows the count of packs checked without metal since the current batch started.
Locks or unlocks the Head Power setting, preventing or allowing automatic adjustment.
Sets the head power automatically during calibration or manually if required.
Specifies the time interval between automatic PV Test prompts.
Configures minimum and maximum threshold limits for ISC operation.
Locks the keyboard to prevent unauthorized access, defaulting display to signal level.
Menu typically used by LOMA service personnel for system diagnostics and settings.
Displays machine software version and machine ID, which can be edited.
Allows manual adjustment of calibration parameters set during commissioning.
Sets the maximum allowable threshold for product contamination detection.
Sets the lowest acceptable threshold to ensure adequate allowance for product variation.
Enters or edits the product name used in results and reports.
General| Brand | Loma |
|---|---|
| Model | Superscan Micro ISC |
| Category | Metal Detector |
| Language | English |
