105
18-10-2004
18-10-2004
00
REG. CODE
1-5302-662
MODEL N°
51092
DATE OF ISSUE
REVISION
ENDORSED
COMPILER TECO/ATI
DATE
351 352
XI
354
353
1
355 355a
DISASSEMBLY/REASSEMBLY
Tappet cover - Assembly
After replacing the rubber sealing ring 1 (fig. 351), reassemble the tappet cover and tighten the four M 6x20 fixing screws at 8
a torque of Nm (fig. 351-352)
Fuel exhaust pipe - Assembly
Use the special pliers to connect the pipe (RILSAN) to the injector and, on the
opposite end, to the two-way banjo.
Fasten the banjo to the union on the injection pump by using a M 8 union bolt tightened
at 20÷25 Nm (fig. 353).
Injector-injection pump connecting pipe - Assembly
Assemble the injector-injection pump pipe and tighten it at a 18÷20 Nm torque (fig.
354)
Air shroud and stator support – Timing
belt cover - Assembly
Reassemble the air shroud and stator
support and fasten it by means of the six
screws: 4 to 20÷22 Nm and two with the
cross-head screwdriver (fig. 355).
After fitting the timing belt cover using both
a slot-head and a cross-head screwdriver,
screw the six fixing screws (fig. 355a).
To Next Page
Loading...
